Extech 5-Frequency Passive Component LCR Meter
The Extech 5-Frequency Passive Component LCR Meter measures inductance, capacitance, and resistance.
Features
- Auto select measurement function with 1kHz default test frequency
- Five test frequencies
- Set high/low limits using absolute values or percentage limits
- Free ground shipping
- Expedited repair and warranty service
- Lifetime technical support
- More
The Extech Passive Component LCR meter accurately measures capacitors, inductors and resistors using the test frequencies of 100Hz, 120Hz, 1 kHz, 10kHz, and 100kHz. The dual display will simultaneously display the associated quality factor, dissipation or phase angle value using a series or parallel equivalent circuit. The meter includes 5 frequencies, including an auto select function with 1kHz default test frequency. User select high/low limits using the absolute values or percentage limits. Open and short calibration removes unwanted stray impedances from the measurement.
- LCD size: 66.8x52.8mm with green backlight
- Test frequency: 100Hz, 120Hz, 1KHz, 10 KHz, 100KHz
- Dissipation factor: 0.000 to 1999
- Quality factor: 0.000 to 1999
- θ Measurement: +/-90°
- Sorting tolerance: +/-0.25%, +/-0.5%, +/-1%, +/-2%, +/-5% +/-10%, +/-20%, +80% -20%
- Calibration: open/short calibration
- Data output: RS232/USB PC computer interface
- Power off: auto shut off saves battery life or manual off by push button
- Operating temperature: 0 to 50 °C
- Operating humidity: less than 85% RH
- Power supply: 006P DC 9V battery
- Power consumption: DC 35mA approx.
- Dimension: 193x88x41mm
- Weight: 385g
- (1) LCR meter
- (1) Pair of test leads
- (1) 9V battery
- (1) Carrying case
Select Options
In The News
Cal Poly, San Luis Obispo Manages Monitoring Efforts in Morro Bay
California Polytechnic State University, San Luis Obispo (Cal Poly, SLO), has been monitoring Morro Bay for decades, and while the monitoring program has changed over the years, the dedication to monitoring the bay has remained the same. The project started in 2006 as a Packard Foundation-funded initiative to monitor water quality flowing in and out of Morro Bay. The goal at the time was to use the data collected to develop and inform an ecosystem-based management plan in collaboration with the Morro Bay National Estuary Program (MBNEP). Since the estuary was the focus at the time, researchers were monitoring water flowing into the estuary from Chorro Creek and Los Osos Creek.
Read More
Green Water in Green Bay: Using Data Buoys to Monitor the Southern Bay
While the bay of Green Bay has been referred to as the largest freshwater “estuary” in the world, the watershed hosts intensive agriculture and contributes one-third of Lake Michigan’s total phosphorus load. The Fox River flows into the bay, carrying excess nutrients largely the result of non-point source runoff from the watershed. With a history of deterioration extending well into the last century, the bay ecosystem suffered significant declines in water quality. This, in turn, stimulated major clean-up and ongoing restoration efforts to improve water quality. Tracking these changes is an important aspect of ecosystem management.
Read More
Cross-Border Sewage Contaminated Flows: Monitoring the Tijuana River
The Tijuana River runs across the US-Mexico boundary, flowing into and throughout southern California, carrying with it nutrients and contaminants throughout the estuary. In recent decades, the flows have been heavily polluted with untreated sewage from the City of Tijuana. The wastewater enters the greater Tijuana River estuary, impacting coastal communities and disrupting the natural environment. In order to better understand these cross-border flows, researchers out of San Diego University sought to monitor the waterway test the capabilities of in-situ sensors to measure the contaminated water. Natalie Mladenov and Trent Biggs were two of the researchers involved in the project, deploying a real-time monitoring system in May of 2021.
Read More
