KISTERS TB3 Tipping Bucket Rain Gauge
Features
- Long-term stable calibration
- Accuracy not affected by rainfall intensity
- Minimal maintenance required
- Free ground shipping
- Expedited repair and warranty service
- Lifetime technical support
- More
Overview
The KISTERS TB3 is a high-quality tipping bucket rain gauge for measuring rainfall and precipitation in urban and rural locations. Due to the integrated siphon, the gauge delivers high levels of accuracy across a broad range of rainfall intensities.
Reliable Results
The TB3’s tried and proven design ensures long-term, accurate, and repeatable results. It is manufactured from high-quality, durable materials that provide long-term stability in the harshest environments. It consists of a robust powder-coated aluminum enclosure, an aluminum base and stainless steel finger filter and fasteners.
Easy Maintenance
TB3 provides a finger filter that ensures the collector catch area remains unblocked when leaves, bird droppings and other debris find their way into the catch. The TB3’s base incorporates two water outlets at the bottom, allowing water collection and data verification. Maintenance of the TB3 is easy because removal of the outer enclosure and access to the tipping bucket mechanism and finger filter can be done by using the quick-release fasteners.
Dual Output
TB3 includes a dual output 24 VDC reed switch allowing for output redundancy or the addition of a second data logger. The reed switch incorporates varistor protection against surges that may be induced on long, inappropriately shielded signal cables.
Resolution | 0.1 mm, 0.2 mm, 0.5 mm, 1.0 mm, 0.01 inch |
Accuracy |
|
Range | 700 mm per hour |
Material |
|
Pivots | Round sapphire pivots with hard stainless steel shaft |
Dimensions & Mass |
|
Environmental Conditions |
|
In The News
Cal Poly, San Luis Obispo Manages Monitoring Efforts in Morro Bay
California Polytechnic State University, San Luis Obispo (Cal Poly, SLO), has been monitoring Morro Bay for decades, and while the monitoring program has changed over the years, the dedication to monitoring the bay has remained the same. 
 
The project started in 2006 as a Packard Foundation-funded initiative to monitor water quality flowing in and out of Morro Bay. The goal at the time was to use the data collected to develop and inform an ecosystem-based management plan in collaboration with the Morro Bay National Estuary Program (MBNEP). 
 
Since the estuary was the focus at the time, researchers were monitoring water flowing into the estuary from Chorro Creek and Los Osos Creek.
Read MoreGreen Water in Green Bay: Using Data Buoys to Monitor the Southern Bay
While the bay of Green Bay has been referred to as the largest freshwater “estuary” in the world, the watershed hosts intensive agriculture and contributes one-third of Lake Michigan’s total phosphorus load. 
 
 The Fox River flows into the bay, carrying excess nutrients largely the result of non-point source runoff from the watershed. With a history of deterioration extending well into the last century, the bay ecosystem suffered significant declines in water quality. 
 
 This, in turn, stimulated major clean-up and ongoing restoration efforts to improve water quality. Tracking these changes is an important aspect of ecosystem management.
Read MoreCross-Border Sewage Contaminated Flows: Monitoring the Tijuana River
The Tijuana River runs across the US-Mexico boundary, flowing into and throughout southern California, carrying with it nutrients and contaminants throughout the estuary. In recent decades, the flows have been heavily polluted with untreated sewage from the City of Tijuana. 
 
The wastewater enters the greater Tijuana River estuary, impacting coastal communities and disrupting the natural environment. In order to better understand these cross-border flows, researchers out of San Diego University sought to monitor the waterway test the capabilities of in-situ sensors to measure the contaminated water. 
 
Natalie Mladenov and Trent Biggs were two of the researchers involved in the project, deploying a real-time monitoring system in May of 2021.
Read More